ABOUT SOLAR ENERGY
Solar energy causes no emissions during operation and during the production of SOLAR COLLECTOR's energy consumption low by comparison with the amount of energy can be produced during its lifetime. There are several techniques for abstraction as well as electrical energy from the sun. The most common are solar cells, which convert the sun's rays into electricity and SOLAR COLLECTOR that converts them into heat.
For us it is important that you get the power you can assimilate, and an attractive design.
We help you with the right design for your savings should be maximum.
Our success factors for effective solar heating system
The solar panel: An advanced technology for the construction of vacuum tubes and optimum thermal conductivity to the fluid medium makes our SOLAR COLLECTOR's to one of the most cost-effective.
![]()
Right sizing: Design work is crucial for the exchange of efficiency and economic returns. Oversize plants is
not completely unusual and gives a dollar invested in poor performance.
The effect: The number of kWh that the household can save by SOLAR COLLECTOR's is the most important factor. With the right number of vacuum tubes so you can get the power you can assimilate in one year. It gives a maximum savnings on your investment.
Vacuum tubes
Even if the sun does not appear to be a vacuum tube to give effect, it is because it also can take advantage of
IR steel no.
IR = Infrared radiation is also known as thermal radiation because it can not be seen, but felt as heat.

The vacuum tube is made of borosilicate glass and is constructed with a full 12 layers. The inner layer is designed to vacuum tube must withstand high temperatures (up to 380 ° C) without reducing tube life.
U-pipe
One copper goes into the vacuum tube and turns into a U. The copper tube is circulating a heat transfer
fluid that cools air in the vacuum tube and carrying away the heat to such a storage tank.

Heat Pipe
![]() |
![]() |
|
Infrared camera image
|
A heat pipe is a copper rod that is installed in the inner tube. Copper rod containing a small amount of a volatile, giftlös liquid when heated to release steam. When the liquid in the tube is heated by the sun will rise on up and then released into steam, which rises to the top of the pipe, which is connected to the heat exchanger. It then emits its heat, condenses, and turns into liquid form again, the liquid flows down to the bottom of the tube and the procedure repeated.
Radiation
The total radiation power from the sun is 3.8 * 1026W but only 17 * 1013W hits the earth. The solar radiation reaching the Earth's atmosphere outermost corresponds to an average power of 1370 W/m2 which is what we call the solar constant. There is a lot of gas in the way such as oxygen, ozone, carbon dioxide and water vapor. Of the solar radiation not absorbed by the electricity. reflected back remains 1000W/m2 reaching the surface. Equator has a larger average of solar radiation than north-south broad degrees when the incidence angle is near 90 ° and the distance through the atmosphere is shorter.
World sunshine map

Products
Calculate examples
- House (Munich, Germany)
- Tenement / Apartments (Munich, Germany)
Datasheet
-
SOLAR COLLECTOR
SOLAR COLLECTOR U-pipe U16/1800
Heat exchanger
- Heat exchanger S9000
-
PLC
PLC control -
Suncarry
Brochure Suncarry

